ONEAC(8) NUT Manual ONEAC(8)NAMEoneac - Driver for Oneac UPS equipment
NOTE
This man page only documents the hardware-specific features of the
oneac driver. For information about the core driver, see nutupsdrv(8).
SUPPORTED HARDWARE
This driver supports Oneac EG and ON UPS equipment with the Advanced
Interface. If your UPS is equipped with the Basic Interface card, use
the genericups driver.
EXTRA ARGUMENTS
This driver supports the following optional settings in the ups.conf(5)
file:
testtime=num
Change battery test time from the 2 minute default.
INSTANT COMMANDS
This driver supports the following Instant Commands.
reset.input.minmax
Reset the minimum and maximum input line voltage values seen since
the last reset or power on.
test.battery.start
Start a battery test. The default time is 2 minutes. This time can
be set in the ups.conf file. See testime above.
test.battery.stop
Stops a battery test that is in progress.
test.failure.start
Starts a 15 second long simulation of an input power failure.
AUTHOR
Eric Lawson <elawson@inficad.com>
SEE ALSO
The core driver:
nutupsdrv(8)
Internet resources:
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/
Network UPS Tools 09/15/2011 ONEAC(8)